9 inch ford back end or dana 44 c4
Joined: Jun 2000
Posts: 5,364
Likes: 51
From: Enschede, Netherlands
Car: 82 TA 87 IZ L98 88 IZ LB9 88 IZ L98
Engine: 5.7TBI 5,7TPI 5.0TPI, 5,7TPI
Transmission: T5, 700R4, T5, 700R4
Axle/Gears: 3.08, 3.27, 3.45, 3.27
Re: 9 inch ford back end or dana 44 c4
9" solid axle vs C4D44 HD? The 9" will be a lot easier. There's a guy on ebay selling 3rd gen housings for 9" guts
Joined: Aug 2006
Posts: 12,803
Likes: 103
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: 9 inch ford back end or dana 44 c4
You realize the corvette rear is independant and will not install into the car with massive fabrication right?
Best also depends on what you want to do with the car
Best also depends on what you want to do with the car
Senior Member
iTrader: (1)
Joined: Feb 2000
Posts: 720
Likes: 0
From: Shakopee, Mn
Car: 89 Iroc
Engine: 305TPI
Transmission: T5
Re: 9 inch ford back end or dana 44 c4
To me comparing those two rearend setups is like comparing beer to bacon. Both are fantastic, but for completely different reasons.
Thread
Thread Starter
Forum
Replies
Last Post
sailtexas186548
Engine/Drivetrain/Suspension Parts for Sale
8
Jan 19, 2016 12:21 PM