Are third and fourth gen track bar the same. Many of these third gen have bolts that are seazed up and got a cut the bolt. If fourth are the same that would be nice

 

You can get a new OE track bar from Rock Auto for about $30.

 

Yes they are the same. The bolts are also the same.

Personally I wouldn't put a junkyard Panhard bar on my car whether off a 3rd or 4th gen, or even a new OE one; but the bolts, used ones are fine.

 

When I pulled my panhard rod off to do the 4th gen tank install I noticed my bolts were deeply pitted along the shank, so I came across a 4th gen in the junk yard and took those bolts since they are actually tapered and I haven't found replacements online. Same bolt.

 

I see no menchen of a panhard bar in the manual. But I've noticed the lower track bar is refers to as such. My upper bar is the one I needed. I got both and compaired them and decided 15.00 was OK for both with bolts like new off a 4th gen. Now the gas tank and straps look like they would work.will they? The after market pan bar,how much they run. What's wrong with stock for a daily driver?

 

Pick it up with your hands and bend it. Go ahead, twist it too.

Is that what YOU want under YOUR car? Not me.

 

How much do the aftermarket cost? I got a admit there are some very good upgrades for our cars out there. Now I've got a body or two worth fixing up,I may start looking into them.

 

It depends on what manufacturer you go with. Ours start as low as $47.25.

https://www.foundersperformance.com/.../panhard-rods/