Strut mount alignment
#1
Strut mount alignment
I had my struts and mounts replaced awhile back, and I just noticed today that they are not the same on both sides. The passenger side is centered and the driver side is pushed all the way to one side. Is this an issue? There is a pull to the right even though it's supposedly aligned properly.
And yes, those caps are glued on. He couldn't figure out how to get them into the new mounts.
And yes, those caps are glued on. He couldn't figure out how to get them into the new mounts.
#3
Re: Strut mount alignment
No, it was awhile back and they never gave me a printout. They blamed the pulling on the Kumho Ecsta tires. I won't be using that alignment shop again.
The man who installed the struts, mounts, and tie rod ends has since retired and closed up shop.
The man who installed the struts, mounts, and tie rod ends has since retired and closed up shop.
Trending Topics
#8
Supreme Member
iTrader: (2)
Join Date: Apr 2000
Location: South Windsor, CT
Posts: 1,316
Likes: 0
Received 229 Likes
on
193 Posts
Car: '89 GTA
Engine: ZZ6TPI
Transmission: T56
Axle/Gears: Borg Warner 3.70:1
Re: Strut mount alignment
Sounds like you need to go to a better alignment shop. If it's pulling to one side, very likely not the tires.
#9
Re: Strut mount alignment
On my last two Irocs, they weren't identical after alignment. Not quite as different as yours, but noticeable without having to measure. If the car is driving and steering well, not pulling and the tires aren't wearing, I wouldn't worry too much. STILL.....getting another alignment isn't overly pricey. might not be a bad idea.
Thread
Thread Starter
Forum
Replies
Last Post
Chevy86 IROC-Z
Suspension and Chassis
27
06-03-2012 09:56 PM