TBI MOD 1
#1
Member
Thread Starter
Join Date: Jun 2010
Location: Holly Springs NC
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 iroc
Engine: 350 30 over
Transmission: T5
Axle/Gears: Series 2 373
TBI MOD 1
had not much to do today when I got home from work so I
Dismattled the tbi from my 305 and did the 1st mod
one side ground down
both sides done
next was to flare the grind down to make a nice flow for air
Dismattled the tbi from my 305 and did the 1st mod
one side ground down
both sides done
next was to flare the grind down to make a nice flow for air
Last edited by trafficlightguy; 01-09-2012 at 09:09 PM. Reason: added more photos
#2
Member
Join Date: Aug 2011
Location: Baltimore, Maryland
Posts: 462
Likes: 0
Received 0 Likes
on
0 Posts
Car: '90 RS
Engine: 305 TBI
Transmission: 700R4
Axle/Gears: 2.73 Open
Re: TBI MOD 1
Nice progress you're making here. What are you using for this, a dremel tool or a die grinder?
#3
Member
Thread Starter
Join Date: Jun 2010
Location: Holly Springs NC
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 iroc
Engine: 350 30 over
Transmission: T5
Axle/Gears: Series 2 373
Re: TBI MOD 1
air powered die grinder and then 80 grit sand paper on a spindle
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
2
09-11-2015 11:09 PM