Quick! I need Knock Sensor Help
Thread Starter
Junior Member
Joined: Oct 2001
Posts: 94
Likes: 0
From: Mankato, Minnesota
Quick! I need Knock Sensor Help
Hey Guys-
I need to know if there is any other place i can screw my knock sensor in on my block because my conversion motor mounts cover my spot by the starter.
let me know asap
nate
I need to know if there is any other place i can screw my knock sensor in on my block because my conversion motor mounts cover my spot by the starter.
let me know asap
nate
Supreme Member
Joined: Sep 1999
Posts: 7,072
Likes: 13
From: Philly, PA
How about the other side of the motor? Only a block mounting location will work and the coolant drain plugs are about the only place I can think to screw one in.
If you'd like to deactivate the knock sensor you can do so by simply running the wire through a 3900 Ohm resistor to ground until you figure out an alternate solution. Just to get you up and running.
If you'd like to deactivate the knock sensor you can do so by simply running the wire through a 3900 Ohm resistor to ground until you figure out an alternate solution. Just to get you up and running.
Thread
Thread Starter
Forum
Replies
Last Post
FormulasOnly
Tech / General Engine
3
Sep 10, 2015 09:07 PM