Car ishard to start when cold- why?
Thread Starter
Junior Member
Joined: Jun 2002
Posts: 25
Likes: 0
Car ishard to start when cold- why?
Ok, two weeks ago, I changed the spark plugs, cap & rotor, and wires. I installed an MSD coil as well. I sprayed carb cleaner into the TPI plenum and throttle body to clean them out; good and clean.
But, it is hard to start when cold. Any ideas? When it fires it runs smooth and well. So i know the fuel injectors are ok...
1992 350TPI. I am baffled!
Any help is appreciated. Thanks in advance...
The Josh
But, it is hard to start when cold. Any ideas? When it fires it runs smooth and well. So i know the fuel injectors are ok...
1992 350TPI. I am baffled!
Any help is appreciated. Thanks in advance...
The Josh
Supreme Member
Joined: Jun 2001
Posts: 1,522
Likes: 0
From: Indianapolis IN
Has it always done this, or is this a new symptom? When you say hard to start, is that just a long crank to start, or is it actually spinning slow? Does it just hit a couple of cylinders and then start? Please be more specific. It could still be dirty injectors. I wouldn't rule that out because it idles well. The continuous adjustment by the computer helps that out. The higher air velocity also helps atomizations as compared to cranking speed.
Last edited by ATOMonkey; Jul 25, 2002 at 08:33 AM.
Thread
Thread Starter
Forum
Replies
Last Post