Clutch Pedals
Thread Starter
Senior Member
Joined: Sep 1999
Posts: 545
Likes: 0
From: Fairfax, VA
Car: 1987 Trans Am
Engine: LT1
Transmission: T-56
Axle/Gears: 10 Bolt SLP Torsen, 3.73 ratio
Clutch Pedals
Can we use 4th gen clutch /brake pedals? Or are thirdgens specific?
I am sorry about all these messages, but it seemed like when someone knowledgeabe read my last post they read rear main seal and then spouted off nonsense that didn't go with the question I was asking.
Thanks
I am sorry about all these messages, but it seemed like when someone knowledgeabe read my last post they read rear main seal and then spouted off nonsense that didn't go with the question I was asking.
Thanks
Member
iTrader: (1)
Joined: Feb 2001
Posts: 396
Likes: 0
From: kentucky
Car: 1990 GTA
Engine: L98
Transmission: manual/t56
There is a tech article about swapping in a t56 on this site that says to get a pedal from an 84-97 assembly. I would try the trans board for a little more info on this swap though. good luck
Thread Starter
Senior Member
Joined: Sep 1999
Posts: 545
Likes: 0
From: Fairfax, VA
Car: 1987 Trans Am
Engine: LT1
Transmission: T-56
Axle/Gears: 10 Bolt SLP Torsen, 3.73 ratio
I swear I scoured that damned article and didn't see it! lol ok, well I got a brain and did an i.e. ctrl-f and found it....should've done that in the first place
Thread
Thread Starter
Forum
Replies
Last Post




First time I read through it I saw the years but I didn't notice it was 84-97. I thought it was just to 92. Oh well, live and learn right. 