Hi,
I can't seem to figure out how these mount onto the caliper assembly. Im talking about the weight or dampener that mounts on the e brake bracket somehow. Every way I try to mount the dampener it fits sloppily or not at all. Does anyone have a picture or can explain how these mount. I have a diagram from gm that is of little help. Thanks
Rob

------------------
'88 Formula 305 TBI, Jet-hot Edelbrock TES, SLP catback,
Open Element, Functional hood scoop, good intake casting,
9 bolt BW 3.45 Posi w/pbr disc setup, Spohn LCA's & Panhard,
Aluminum driveshaft, Trans-go shift kit, March underdrive,
Hypertech stage II, 160 stat, Bilstien shocks, Resistor mod..

 

Altho these are the old-style rear disc calipers, I was missing the dampener entirely on the 84 3.73/posi/disc axle assembly I just purchased. I know what you mean about the diagram, I'm not sure how they'd be mounted either. Maybe you can run without 'em?

-Tom P (Hot rodded 1986 Firebird 2.8l) from http://www.v6fbody.com mailbags

 

All the dampener does is reduces the howl noise when backing up.

 

Thanks for the info Blak92. I would still like to bolt these on though. There are two possible holes on the brackets but it seems the actual dampener rests loosely on the assembly. Any ideas?

------------------
'88 Formula 305 TBI, Jet-hot Edelbrock TES, SLP catback,
Open Element, Functional hood scoop, good intake casting,
9 bolt BW 3.45 Posi w/pbr disc setup, Spohn LCA's & Panhard,
Aluminum driveshaft, Trans-go shift kit, March underdrive,
Hypertech stage II, 160 stat, Bilstien shocks, Resistor mod..

 

Come on...someone has to know this.

------------------
'88 Formula 305 TBI, Jet-hot Edelbrock TES, SLP catback,
Open Element, Functional hood scoop, good intake casting,
9 bolt BW 3.45 Posi w/pbr disc setup, Spohn LCA's & Panhard,
Aluminum driveshaft, Trans-go shift kit, March underdrive,
Hypertech stage II, 160 stat, Bilstien shocks, Resistor mod..