TB bypass question.... HELP!
Thread Starter
Junior Member
Joined: Sep 2000
Posts: 1
Likes: 0
From: West Lafayette Ohio
TB bypass question.... HELP!
I did the TB bypass this summer when I installed my miniram....what I did was just plug it off. After the install I had no heater...is the TB bypass part of the heater system?? Thanks!!
350Iroc aka 350Z
350Iroc aka 350Z
Supreme Member
iTrader: (8)
Joined: Jan 2000
Posts: 3,968
Likes: 1
From: Macedonia ,OH
Car: Formula
Engine: 6.0 LSX
Transmission: 4L60E
Axle/Gears: 9 Bolt 3:27
What did you plug off? Only thing to plug off is the holes on the TB Should have hose from heater valve to the Manifold. Hope you put the hose on the right outlet on the valve.
PS not part of the heating system.
[This message has been edited by Mkos1980 (edited September 19, 2000).]
PS not part of the heating system.
[This message has been edited by Mkos1980 (edited September 19, 2000).]
Moderator
Joined: Jan 2000
Posts: 19,659
Likes: 310
350,
You need to maintain flow through those hoses, even if the flow does not route through the TB base. The hot water from the back of the head needs to recirculate to the water pump to scavenge air and steam from the end os the head. You should have installed a splice in the two hose ends to complete the job.
------------------
Later,
Vader
------------------
"Make Me Bad"
Adobe Acrobat Reader 4.0
You need to maintain flow through those hoses, even if the flow does not route through the TB base. The hot water from the back of the head needs to recirculate to the water pump to scavenge air and steam from the end os the head. You should have installed a splice in the two hose ends to complete the job.
------------------
Later,
Vader
------------------
"Make Me Bad"
Adobe Acrobat Reader 4.0
Thread
Thread Starter
Forum
Replies
Last Post
