I currently have a 305 tbi in my 89 camaro, the engine has 152000 miles on it, and to say the least it's in a state of disrepair. I was just wondering what you guys think is a fair price for a rebuilt 350 so I don't get shafted when I start looking around. Thanks

 

short block or long block? stock bore or over bore? 2 bolt or 4 bolt? roller or non-roller? LoL Need a little bit more info

 

Hmm I'd say it depends on the rebuild quality.. If it was a complete overhaul (including heads) I'd pay about 350 bucks for it.. If it was just basics like bearings, rings and gaskets, maybe 200 or 250.

 

short block, over bore, 2 bolt main, roller. It seems that everywhere I look there going for like $1000-$1500.

 

by short block that means Crackshaft connectiong rods and pistons all ready installed. if your getting all that and its a roller block i say thats a good deal. i'm looking on E-bay right now for just a bare block and that are going for around $300-$500 and thats means that need to be bored, cam bearing pressed in, decked and all that other stuff. the crankshaft cost about $400 (i think) plus the cost of pistons,rings, and bearing so $1,000 - $1,500 is a good deal is its a true short block