Cam torque specs. 20ft.lbs??
Thread Starter
Junior Member
Joined: Jul 1999
Posts: 73
Likes: 0
From: Concord, CA
Cam torque specs. 20ft.lbs??
My memory isn't that great, and I forgot where I put my chiltons 
. Is 20#'s good enough for the cam bolts? Also should I put anything on the threads to prevent it from loosening? Thanks guys.
. Is 20#'s good enough for the cam bolts? Also should I put anything on the threads to prevent it from loosening? Thanks guys. 
Moderator
Joined: Jan 2000
Posts: 19,679
Likes: 316
Mike,
The spec for a SBC is 21 lb/ft (28 Nm). You do not have to apply a thread locking compound, If you are concerned, you could use a mild Loctite (like 242) or you can get a retainer plate that has locking tabs to secure the bolts.
I;ve never had a bolt come loose on the cam sprocket if properly torqued, but it could happen under severe circumstances, thus the availability of the plate.
------------------
Later,
Vader
------------------
"Make Me Bad"
Adobe Acrobat Reader 4.0
The spec for a SBC is 21 lb/ft (28 Nm). You do not have to apply a thread locking compound, If you are concerned, you could use a mild Loctite (like 242) or you can get a retainer plate that has locking tabs to secure the bolts.
I;ve never had a bolt come loose on the cam sprocket if properly torqued, but it could happen under severe circumstances, thus the availability of the plate.
------------------
Later,
Vader
------------------
"Make Me Bad"
Adobe Acrobat Reader 4.0
Thread
Thread Starter
Forum
Replies
Last Post