SLP cam, identification problem.
Thread Starter
Junior Member
Joined: Sep 2000
Posts: 62
Likes: 0
From: Finland
Car: GTA '88
Engine: 420 Dart SHP
Transmission: T-56
SLP cam, identification problem.
Hi!
I got my hands on a cheap SLP's roller cam. The problem is that the cam card is missing.
It's from an -88 GTA 350 trans am w/auto, 3.23 posi.
There is a stamped serial no. 109356 on it. The seller claims that the values are about: 270/260 lift 0.47/0.46
If anyone knows the values and power range and required springs etc. I would be grateful!
It would be installed on a -88 GTA 305tpi w/T5, 3.45 posi, Haltech ECM.
Jake
I got my hands on a cheap SLP's roller cam. The problem is that the cam card is missing.
It's from an -88 GTA 350 trans am w/auto, 3.23 posi.
There is a stamped serial no. 109356 on it. The seller claims that the values are about: 270/260 lift 0.47/0.46
If anyone knows the values and power range and required springs etc. I would be grateful!
It would be installed on a -88 GTA 305tpi w/T5, 3.45 posi, Haltech ECM.
Jake
Senior Member
Joined: Jul 1999
Posts: 851
Likes: 1
From: Shelby Twp., Mi., USA
Car: '84 Fiero ('01 GA interior)
Engine: '96 4.0 Aurora
Transmission: '96 4T80E
You should post your question on the SLP parts board SLP Board The guys there are pretty helpful.
[This message has been edited by RCR (edited October 19, 2000).]
[This message has been edited by RCR (edited October 19, 2000).]
Thread
Thread Starter
Forum
Replies
Last Post
