Will an Edelbrock Torker manifold bolt onto my 305 TBI?
Thread Starter
Member
Joined: Jan 2000
Posts: 114
Likes: 0
From: Hatteras, Greenville, NC Age:20
Will an Edelbrock Torker manifold bolt onto my 305 TBI?
I'm swapping to carb and this guy will sell me a 600 cfm carb and a what-looks-like-torker manifold for $100. Will the manifold bolt on to my stock 305 TBI heads?
------------------
92 RS 305 TBI 5-speed
...no times yet
it'll do 145 mph though
------------------
92 RS 305 TBI 5-speed
...no times yet
it'll do 145 mph though
Supreme Member
Joined: Jul 1999
Posts: 1,431
Likes: 1
From: Huntsville, AL
Car: '00 Chevrolet Corvette
Engine: LS1
Transmission: 4L60E
Axle/Gears: 2.73
It will require some modification to make it bolt up, assuming that you've still got the stock heads. The stock center-bolt valve cover heads have some different intake bolt angles than the older perimeter-bolt valve cover heads. I'm not sure exactly which bolt holes will require modification, somebody else will have to help you there...
-Mark W.
'88 SC Camaro w/ 305 TBI
-Mark W.
'88 SC Camaro w/ 305 TBI
Senior Member
Joined: May 2000
Posts: 689
Likes: 62
From: Central NJ
its the 2 middle bolts on each side...
------------------
350, Comp 262, Edelbrock Performer intake 600 cfm carb and exhaust, headers
[This message has been edited by CamaroZ_85 (edited October 29, 2000).]
------------------
350, Comp 262, Edelbrock Performer intake 600 cfm carb and exhaust, headers
[This message has been edited by CamaroZ_85 (edited October 29, 2000).]
Thread
Thread Starter
Forum
Replies
Last Post
