I have an 87 IROC 5.0. Some of the vacuum piping broke during a rebuild. This is the hard plastic type the connects up the EGR etc.. The dealer says the stuff is discontinued, so what do I do??

 

Just get some rubber vacuum hose and put it over the plastic hose. I may not look the best, but works just fine.

------------------
Rob
'86 TA 305 TPI

 

the 3/16 x 2" vaccume hose connector works great for putting those hard lines together
you can find them in the motormite section at pepboyz

------------------
TPIS airfoil,relocated MAT,AFPR,TB h2o bypass
otherwise stock 5.0TPI
700r4, 9 bolt 3.23 g92 axle, 4 wh. disc brks.

 

I broke some of the same stuff on my fuel pres reg and went to parts america and there it was in rolls of like 10 feet.

I seriosly think you should be able to find this stuff at a parts store and if you are lucky they will have the elbows too.

James

------------------
88 T/A 305 TPI--
K&N,Air foil,hypertech chip, thermostat+fanswitch
no MAF screens, no cat, dynomax exh, urethane motor+trans mounts,
SSM frame con, Bilsteins
homemade ramair.

 

Advance Auto has it as well, I seen it yesterday.

------------------
wishmister@yahoo.com

1987 White IROC-Z
305 TPI LB9 273 Rear Gear
700-R4 auto tranny
97,000 miles
KYB's
Performance Resource Chip
Flowmaster Muffler
Ported/Polished Plenum by "Daniel Burk"
Holley AFPR
Throttle Body Coolant bypass
TPIS air Foil
TPIS MAT Relocation Kit
K&N's
Gutted air box
Accel 8.0 plug wires
Moroso Super Coil
Blue Streak Cap and Rotor
Boush Patinum +4's
Mobil 1 15/50 Synthetic motor oil
Mobil 1 synthetic Trans fluid.