those with performer rpm intake please help
Thread Starter
Junior Member
Joined: Dec 2001
Posts: 65
Likes: 0
From: Charleston,West Virginia, USA
those with performer rpm intake please help
I'm building a 355 with the performer rpm package at the moument and should have it ready to drop in within a months time, my only question is, will my stock hood clear the taller intake, as is there's not much room under my hood so if anyone has this ontake I'd greatly appreciate you're knowledge on this subject.
Supreme Member
Joined: Sep 2001
Posts: 6,111
Likes: 53
From: Ontario, Canada
Car: 1988 Firebird S/E
Engine: 406Ci Vortec SBC
Transmission: TH-350/3500stall
Axle/Gears: 7.5" Auburn 4.10 Posi-Traction
see this thread
https://www.thirdgen.org/techbb2/sho...&highlight=L88
This is the lowest available aircleaner assembly.
With a holley carb you want to shorten or remove the choke horn so the carb can breathe right.
But it fits.
https://www.thirdgen.org/techbb2/sho...&highlight=L88
This is the lowest available aircleaner assembly.
With a holley carb you want to shorten or remove the choke horn so the carb can breathe right.
But it fits.
Supreme Member
iTrader: (1)
Joined: Feb 2000
Posts: 7,964
Likes: 4
From: Norfolk, VA. USA
Car: 86 Trans Am, 88 Formula
Engine: 95LT4, 305TPI
Transmission: T56, T5
I had this setup,
Edelbrock 1406 Carb
Edelbrock 14x3 Drop Base Air Cleaner
Edelbrock 7101 Performer RPM Intake Manifold
And it rubbed very slightly at the front of the aircleaner.
I think a Camaro wouldn't have any problems since the hood/fenders don't slope down as much as a Firebird.
Edelbrock 1406 Carb
Edelbrock 14x3 Drop Base Air Cleaner
Edelbrock 7101 Performer RPM Intake Manifold
And it rubbed very slightly at the front of the aircleaner.
I think a Camaro wouldn't have any problems since the hood/fenders don't slope down as much as a Firebird.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Sep 17, 2020 08:26 AM