timing ?
Thread Starter
Senior Member
Joined: Nov 2000
Posts: 601
Likes: 0
From: Queen Creek, AZ
Car: 91 Formula
Engine: 383 HSR
Transmission: 5th 700R4
Axle/Gears: 3.89
timing ?
under what condition should the ECM provide the most advance? And about what should the total advance be at WOT? I read sompthing about 36deg. but did not know if this was total timing under load or what.
Thanks any help would be appriciated.
Marc
------------------
Thanks any help would be appriciated.
Marc
------------------
Supreme Member
Joined: Jul 2000
Posts: 1,014
Likes: 0
From: Kempner,TX,
Car: 1996 Vette / 1992 GSX1100F Suzuki
Engine: 1996 Corvette Coupe 388 LT1 (+.060)
Transmission: Auto
Axle/Gears: 3.07
Part throttle cruise conditions have the most ignition advance to give the best fuel economy.
WOT timing varies based on the engine mods. Most figures I see are in the 36 degree range at WOT.
The part throttle cruise timing is somewhere around 10 degrees more that the WOT.
My TPIS Stage V Prom only has 28 degrees of timing in Power Enrichment Mode, WOT according to Diacom.
Jake
------------------
1986 Corvette Coupe, 415 CID, Edelbrock 6073s, ZZ9
[This message has been edited by JakeJr (edited January 12, 2001).]
WOT timing varies based on the engine mods. Most figures I see are in the 36 degree range at WOT.
The part throttle cruise timing is somewhere around 10 degrees more that the WOT.
My TPIS Stage V Prom only has 28 degrees of timing in Power Enrichment Mode, WOT according to Diacom.
Jake
------------------
1986 Corvette Coupe, 415 CID, Edelbrock 6073s, ZZ9
[This message has been edited by JakeJr (edited January 12, 2001).]
Thread
Thread Starter
Forum
Replies
Last Post