gas milage difference between a 305 and 350?
#1
gas milage difference between a 305 and 350?
I am selling the old v6 and i want to buy a v8, but i wanted to know what the gas milage difference was between a 305 and 350? it's not that important but i did want to know before i bought one. Thanks.
#2
Supreme Member
Join Date: Oct 2000
Location: Lima, Ohio
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
I don't think there is any difference and very little if any at all. The 350 doesn't have to work as hard and has more power. The 350 is a better base to start making more power if your into going fast. You can tune a 350 to get good power and gas mileage.
Brendan
------------------
1987 IROC-Z L98,SuperRam,EB 6085's,LPE 219/219 Roller, Crane 1.6RR, EB TPI Base, 58mm TB, ADS 24#, AFPR, K&N, EB TES, Catco Cat, 3" Borla Cat-Back, Accel cap,rotor,distro/other crap, MSD 6AL, MSD Blaster 3, Aluminum DS, 94 Disk Rear, Adjustable Valve, Precision 3.73 Gears, Sub-Frame Connectors, Hotchkis Lower Control Arms, KYB Shocks/Struts, Suspension Techniques Lowering Springs, Polyurethan Bushings all over the place, Moog Upper/Lower Ball joints and Tie Rods ends/Idler Arm,
To see the ROC, Check out the webpage Here
Brendan
------------------
1987 IROC-Z L98,SuperRam,EB 6085's,LPE 219/219 Roller, Crane 1.6RR, EB TPI Base, 58mm TB, ADS 24#, AFPR, K&N, EB TES, Catco Cat, 3" Borla Cat-Back, Accel cap,rotor,distro/other crap, MSD 6AL, MSD Blaster 3, Aluminum DS, 94 Disk Rear, Adjustable Valve, Precision 3.73 Gears, Sub-Frame Connectors, Hotchkis Lower Control Arms, KYB Shocks/Struts, Suspension Techniques Lowering Springs, Polyurethan Bushings all over the place, Moog Upper/Lower Ball joints and Tie Rods ends/Idler Arm,
To see the ROC, Check out the webpage Here
#3
Senior Member
I have known people to get better gas mileage with a 350 than a 305. Not me of course. I would say that a 350 might get 1-2 mpg less but it just depends on application.
Thread
Thread Starter
Forum
Replies
Last Post
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
08-12-2015 03:41 PM