another valve spring question, part between retainers and springs..
#1
Member
Thread Starter
Join Date: Dec 1999
Location: Cincinnati, Ohio 45215
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
another valve spring question, part between retainers and springs..
On my heads, there are these little "hats" over the valves and the retainers sit on the "hats", with my zz4 cam kit, I have springs and retainers but no hats. Should I re-use the old hats or just stick the retainers right on top of the valve springs???
------------------
-=1987 Formula 350=-
Member Greater Cincinnati F-Body Association
------------------
-=1987 Formula 350=-
Member Greater Cincinnati F-Body Association
#2
TGO Supporter
you don't need them, just the retainer. it'll save you weight in the valve train and give you more spring height. you'd want to make sure you have the correct install height.
------------------
ICON Motorsports
1st & 3rd
------------------
ICON Motorsports
1st & 3rd
#3
Supreme Member
Join Date: Jul 1999
Location: Loveland, OH, US
Posts: 18,457
Likes: 0
Received 15 Likes
on
15 Posts
Car: 4
Engine: 6
Transmission: 5
Right... those are oil shields. They have been known to wear through and the outside part just fall down around the valve and make noise.
Throw them away and use positive valve seals such as the ones from Crane or Comp if they'll fit, and the retainers without the oil splash shields.
------------------
"So many Mustangs, so little time..."
ICON Motorsports
Throw them away and use positive valve seals such as the ones from Crane or Comp if they'll fit, and the retainers without the oil splash shields.
------------------
"So many Mustangs, so little time..."
ICON Motorsports
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
1988iroc350tpi
Tech / General Engine
8
08-14-2015 07:52 PM