spider intake manifolds
Thread Starter
Member
Joined: May 2003
Posts: 138
Likes: 0
From: Easton, MA
Car: 1988 GTA
Engine: 355
Transmission: 700 r4
spider intake manifolds
on a spider intake manifold where the piece that covers the lifter valley is separate from the piece with the intake runners, what holds down the piece over the lifter valley?
TGO Supporter
Joined: Jul 2003
Posts: 4,803
Likes: 2
From: Grand Rapids, MI
Car: Z28
Engine: Sb2.2 406
Transmission: Jerico 4 speed
Axle/Gears: Ford 9" 3.60
It bolts through the upper intake and there are corresponding bolt holes in the valley plate:
These parts are generally considered "race only" and i would advise against using them on the street as their powerband is probably more in line with the tunnel ram setup or so it would seem. That particular setup i showed above is the SB2.2 design (NASCAR).
*EDIT* Doh, just realized, those 2 don't go with eachother
These parts are generally considered "race only" and i would advise against using them on the street as their powerband is probably more in line with the tunnel ram setup or so it would seem. That particular setup i showed above is the SB2.2 design (NASCAR).
*EDIT* Doh, just realized, those 2 don't go with eachother
Last edited by Stekman; Jun 24, 2004 at 03:32 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
Dec 10, 2019 07:07 PM
86CamaroDan
Engine/Drivetrain/Suspension Parts for Sale
2
Sep 29, 2015 10:08 PM
Hotrodboba400
Firebirds for Sale
0
Sep 2, 2015 07:28 PM