Setting Ignition Timing
Thread Starter
Member
Joined: Jul 2001
Posts: 107
Likes: 0
From: Green Brook, NJ
Setting Ignition Timing
When I'm setting my ignition timing I believe I'm supposed to disconnect a black and tan wire. Can someone tell me where I can find this wire specifically on my 83 305?
Thanks,
Adam
Thanks,
Adam
Joined: Mar 2000
Posts: 43,187
Likes: 43
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Bad info. That applies to EFI vehicles.
Coming out of the bottom of the base of your distributor is a flat 4-wire connector that goes to the wiring harness on the firewall. It's sometimes hard to find in the mess of stuff back there. Disconnect it, set timing, reconnect.
Coming out of the bottom of the base of your distributor is a flat 4-wire connector that goes to the wiring harness on the firewall. It's sometimes hard to find in the mess of stuff back there. Disconnect it, set timing, reconnect.
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM
