Breaking in cam
Thread Starter
Member
Joined: Dec 2003
Posts: 170
Likes: 0
From: Atascadero, CA
Car: 88 Iroc
Breaking in cam
What's the correct procedure for breaking in a new roller cam? I know what you're supposed to do for a flat tappet, and i was wondering if it's any different for a roller. Also, is sealer necessary when installing heads?
Supreme Member
Joined: Jul 1999
Posts: 18,457
Likes: 16
From: Loveland, OH, US
Car: 4
Engine: 6
Transmission: 5
Start motor. Operate. When through, stop motor. Repeat as life circumstances dictate. Change oil after 1000 miles.
In other words, no special break-in for roller cams.
In other words, no special break-in for roller cams.
Thread
Thread Starter
Forum
Replies
Last Post
