Cam Selection
Thread Starter
Member
Joined: Feb 2005
Posts: 136
Likes: 0
From: Michigan
Cam Selection
I need some opinions for a cam.I have a '75 flat tappet 350 bored .060 over,airgap intake,750holley dp, 215cc ported and polished dart heads, true duals with long tube headers,built 700r4 tranny with a stall from 2600-3200, 3:42 gears......This car will be doing it all. Daily driver,racing now and then, cruising down the freeway. So id like a few suggestions on what you would use and what brand. thanks
Junior Member
Joined: Nov 2004
Posts: 34
Likes: 0
From: North Carolina
Car: 1992 Firebird Formula
Engine: soon to be 383
Transmission: 700R4 w/2800 stall
With your setup it sounds like you might be better off with a slighty larger cam, if your gonna use a solid flat tappet, id probably go with comp cams XS282S or 294S. If your gonna use hydraulic flat tappet, maybe 292H or XE284H.
Member
Joined: Jan 2001
Posts: 142
Likes: 0
From: In The Garage
Car: 1986 IROC-Z
Engine: SBC
Transmission: Manual Th-350
Axle/Gears: 9" Moser 3.89's Spool.
Im having this debate right now,
Motor is 11:1-1 Compression 355 with 6.0inch rods, Vic Jr intake, Pro Mag 1.5's, AFR195's 68cc heads with std porting.
Trying to Decide on either a XS282S or Magnum 294s.
Motor is 11:1-1 Compression 355 with 6.0inch rods, Vic Jr intake, Pro Mag 1.5's, AFR195's 68cc heads with std porting.
Trying to Decide on either a XS282S or Magnum 294s.
Last edited by IROC4LIFE; Apr 3, 2005 at 04:18 PM.
Thread
Thread Starter
Forum
Replies
Last Post