Im looking into buying new alum. heads but im unsure of which ones to buy my engine consists of:
Goodwrench 350 short block with 40,000 miles

Cast aluminum pistons

4 bolt main

HEADS

L-98 Cast Iron "083" casting corvette style from TPI 350 completely rebuilt.

1.94/1.50 valves

Hi-Compression 64cc combustion chambers

3 angle valve job

New springs, valve seals, guides

Milled and magna-fluxed

VALVE TRAIN

Compcam extreme energy XE268H (PN# 122422) (268/280) (224/230 duration) (.477/.480 lift) (110 degrees LSA)

1600-5800 rpm range

Compcam push rods, double roller timing chain set, lifters.

INTAKE

Holley Street Dominator intake manifold

Holley Street Avenger 770cfm carb

EXHAUST

Hooker Shorty 2055 Headers

Single 3"cat

3.00" Flowmaster catback exhaust

IGNITION

Summit Billet aluminum HEI vacuum advance distributor with 50,000 volt electronics

Summit custom advance curve kit
Accel 300+ Spark plug 8.8mm wires.


Also can i reuse the parts from my old heads like the valves and valve guides or just buy new and which ones should i get if buying new?

Also Is there anything else i can upgrade or do different to get more power from this engine? Its my daily driver so nothing crazy but i want to get more power out of it.