Programming vats out of ECM
Thread Starter
Junior Member
Joined: Feb 2007
Posts: 5
Likes: 0
From: Wisconsin
Car: 92 Formula
Engine: 305 TBI
Transmission: 700R4
Axle/Gears: 3.73
Programming vats out of ECM
I searched a few threads and it sounds like this can be done but does anyone know of a place or a person that could do this, I tried the vats bypass and that didnt work so I assume its the module. Any help would be greatly appreciated.
It's a simple matter of turning one bit in a memory location from a "1" to a "0" (un-checking a flag), then burning the altered program to a blank PROM.
But don't stop there. There is so much more which can be done. There is a complete guid in the DIY/PROM Forum outlining the necessary hardware and procedures.
But don't stop there. There is so much more which can be done. There is a complete guid in the DIY/PROM Forum outlining the necessary hardware and procedures.
Thread
Thread Starter
Forum
Replies
Last Post
1992, 3rd, bodies, bypass, code, ecm, gen, generation, pass, program, programing, programmer, programming, programs, reprogram, reprogramming, tools, vats









