Is this a decent setup?
Thread Starter
Junior Member
Joined: Apr 2007
Posts: 46
Likes: 0
From: Wilmington
Car: 1987 IROC-Z Camaro
Engine: LB9 305, edelbrock intake.
Transmission: 700R4
Axle/Gears: 10 bolt, 3.73 posi w/ disc brakes
Is this a decent setup?
I saw a 383 stroker short block assembely for sale that had
Block DES 4 Bolt, seasoned core, cleaned, magnafluxed, decked w/BHJ fixture, bored, honed w/BHJ torque plates, brass freeze plugs and cam bearings installed, right hand dipstick, painted black standard
Crank DES Forged 4340 steel, 3.750" stroke, 1 piece rear seal.
Pistons Lunati Forged .350" dome, 11.5 compression w/76cc head
Cam & Lifters Lunati Solid flat tappet
Would that be pretty decent for a supercharger applied engine? They are selling it for $3,950.
Block DES 4 Bolt, seasoned core, cleaned, magnafluxed, decked w/BHJ fixture, bored, honed w/BHJ torque plates, brass freeze plugs and cam bearings installed, right hand dipstick, painted black standard
Crank DES Forged 4340 steel, 3.750" stroke, 1 piece rear seal.
Pistons Lunati Forged .350" dome, 11.5 compression w/76cc head
Cam & Lifters Lunati Solid flat tappet
Would that be pretty decent for a supercharger applied engine? They are selling it for $3,950.
Member
Joined: Nov 2003
Posts: 299
Likes: 0
From: The Netherlands
Car: Cobra Kit Car
Engine: 350 HSR
Transmission: TKO 600
Axle/Gears: 3.31
Re: Is this a decent setup?
Watch out for the compression.
A supercharged engine need to run lower compressions that 11.5.
Regards,
Cobra289
A supercharged engine need to run lower compressions that 11.5.
Regards,
Cobra289
Thread Starter
Junior Member
Joined: Apr 2007
Posts: 46
Likes: 0
From: Wilmington
Car: 1987 IROC-Z Camaro
Engine: LB9 305, edelbrock intake.
Transmission: 700R4
Axle/Gears: 10 bolt, 3.73 posi w/ disc brakes
Re: Is this a decent setup?
I hear ya I actually emailed the guys that make it and asked if I could get lower compression pistons and they said they'd include them instead of the 11.5's for free.
Supreme Member
Joined: Oct 2006
Posts: 1,974
Likes: 0
Car: 91 RS
Engine: 350 vortec
Transmission: T-5
Axle/Gears: not the best not the worst
Re: Is this a decent setup?
which heads are on it? doesnt seem like enough money for a decent 76cc head but just enough for some smogger head...
Joined: Mar 2000
Posts: 43,187
Likes: 46
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Thread
Thread Starter
Forum
Replies
Last Post