1 step forward and 10 steps back
Thread Starter
Junior Member
Joined: May 2007
Posts: 52
Likes: 0
From: Austin Texas
Car: 1984 Z28 Camaro
Engine: 305 H.O. 72,000 original miles
Transmission: 700R4
1 step forward and 10 steps back
Well I replaced the timing chain and waterpump on my 84 z28 (305cid) everything was put back together and now the belt that runs form the powersteering pump to the crankshaft is rubbing agianst the water pump pulley. I have a V-belt system. Dont know what to do.
Thread Starter
Junior Member
Joined: May 2007
Posts: 52
Likes: 0
From: Austin Texas
Car: 1984 Z28 Camaro
Engine: 305 H.O. 72,000 original miles
Transmission: 700R4
Re: 1 step forward and 10 steps back
I thought the exact same thing but the alighnment of all of my other belts line up perfectly.
Joined: Sep 2005
Posts: 27,918
Likes: 2,448
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: 1 step forward and 10 steps back
Crank sprocket on upside down, such that the damper can't go on all the way?
Forget for a minute about "line up perfectly", and LOOK at what's wrong. If the front of the PS pump belt rubs the back of the WP pulley, the ONLY POSSIBLE explanation is that the damper isn't on all the way.
Memorize the last line of my signature.
Forget for a minute about "line up perfectly", and LOOK at what's wrong. If the front of the PS pump belt rubs the back of the WP pulley, the ONLY POSSIBLE explanation is that the damper isn't on all the way.
Memorize the last line of my signature.
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM
