Cam timing set question
Thread Starter
Junior Member
Joined: Feb 2005
Posts: 58
Likes: 0
From: Grabill Ind.
Engine: 350 TPI
Transmission: 700r
Axle/Gears: ford 3.55
Cam timing set question
Some timing set crank sprockets have 3 keys. +4, 0 and -4 degrees.If I install the sprocket to the - 4 degrees retard keyway, is this setting the cam 4 degrees or 2 degrees?
Thanks
Thanks
Thread Starter
Junior Member
Joined: Feb 2005
Posts: 58
Likes: 0
From: Grabill Ind.
Engine: 350 TPI
Transmission: 700r
Axle/Gears: ford 3.55
Re: Cam timing set question
If I set the shaft sprocket with the 4degree keyway, it will be the same as using
a 4 degree bushing in the cam sprocket. Sorry for the stupid question. Just do not want to pull the shaft sprocket off again when I go to degree the cam?
Thanks
a 4 degree bushing in the cam sprocket. Sorry for the stupid question. Just do not want to pull the shaft sprocket off again when I go to degree the cam?
Thanks
Joined: Mar 2000
Posts: 43,187
Likes: 43
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Well, I'm not the world's most experienced cam degree'r, but that's pretty integral to the process from my understanding.
Thread
Thread Starter
Forum
Replies
Last Post
