motor mount quest
Thread Starter
Supreme Member
Joined: Jun 2006
Posts: 1,422
Likes: 1
From: alliance, ohio
Car: 1984 chevy camaro
Engine: 355
Transmission: turbo 350 2800 stall
Axle/Gears: 3:73 detroit locker posi
motor mount quest
i just put a new 350 in my car. is there supposed to be a gap in the motor mount on the driverside? the holes linr up but i was just wondering. the passenger side sits flush so i dunno if its not right or what. im going from a 305-350 im using the 350 mounts on the block, is it just that way cause it came out of a truck? basically will it be ok like that. thanks
Last edited by billybob6110; Jun 10, 2008 at 01:49 PM.
Joined: Mar 2000
Posts: 43,187
Likes: 43
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
There should be a gap between the engine side metal mount and the chassis side metal clamshell. The engine side front & back should rest on the metal tabs sticking out of the chassis side rubber inserts.
Thread Starter
Supreme Member
Joined: Jun 2006
Posts: 1,422
Likes: 1
From: alliance, ohio
Car: 1984 chevy camaro
Engine: 355
Transmission: turbo 350 2800 stall
Axle/Gears: 3:73 detroit locker posi
Re: motor mount quest
i had to use my old 305 motor mounts, the 350 ones wouldnt work.. thanks five7kid
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 5, 2015 07:57 PM
