How much power am I making?
Thread Starter
Member
iTrader: (3)
Joined: Nov 2006
Posts: 140
Likes: 0
From: Tescott, Kansas 67484
Car: 1987 Camaro
Engine: 350 dart ies comp cam intake carb
Transmission: 700 r4, shift kit, 2400 stall
Axle/Gears: 10 bolt stock
How much power am I making?
Looking for a rough estimate at the crank, around 20000 miles on rebuild...
Stock 350, bore stroke crank pistons
Dart 180, 64cc Iron Eagles
Xtreme Energy XR264HR Hydraulic Roller Camshaft Only
Lift: .487''/.495''
Duration: 264°/270°
RPM Range: 1200-5200
1.6 Roller Rockers
MSD pro billet
RPM air gap, with a Quickfuel ss750
shorty headers thru a dynomax bullet
i think thats it lmk if you need more info
Stock 350, bore stroke crank pistons
Dart 180, 64cc Iron Eagles
Xtreme Energy XR264HR Hydraulic Roller Camshaft Only
Lift: .487''/.495''
Duration: 264°/270°
RPM Range: 1200-5200
1.6 Roller Rockers
MSD pro billet
RPM air gap, with a Quickfuel ss750
shorty headers thru a dynomax bullet
i think thats it lmk if you need more info
Joined: Mar 2000
Posts: 43,187
Likes: 43
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Which headers? What size exhaust?
You've got more heads and intake than cam. Probably capable of something in the 350-375 GFWHP range, but would need specifics about exhaust to give a better estimate.
You've got more heads and intake than cam. Probably capable of something in the 350-375 GFWHP range, but would need specifics about exhaust to give a better estimate.
Thread Starter
Member
iTrader: (3)
Joined: Nov 2006
Posts: 140
Likes: 0
From: Tescott, Kansas 67484
Car: 1987 Camaro
Engine: 350 dart ies comp cam intake carb
Transmission: 700 r4, shift kit, 2400 stall
Axle/Gears: 10 bolt stock
Re: How much power am I making?
The headers are shorty's and i assume they are a summits or something of that nature (came on the car)
The y-pipe is probably 2 or 2.5" its pretty small and I'm sure the flow is terrible, it was made on the car when I bought it, then it goes into 2.5 into a 3" bullet and turndown under the car.
I want to up the cam, but I am ready for a t56 money permitting and don't want to stall this auto before hand...
The y-pipe is probably 2 or 2.5" its pretty small and I'm sure the flow is terrible, it was made on the car when I bought it, then it goes into 2.5 into a 3" bullet and turndown under the car.
I want to up the cam, but I am ready for a t56 money permitting and don't want to stall this auto before hand...
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Sep 17, 2020 08:26 AM
novaderrik
Transmissions and Drivetrain
3
Aug 10, 2015 12:44 PM