Engine will not crank... Please help..
Thread Starter
Junior Member
iTrader: (4)
Joined: Jun 2008
Posts: 16
Likes: 0
From: Minot Afb, ND
Car: 1988 Chevrolet Camaro
Engine: In the market
Transmission: 700R4
Axle/Gears: 2.77
Engine will not crank... Please help..
Car was running fine, and one day i turn the key and the engine cranks one time then nothing. This happens every time. I had the battery and the alternator tested, they are fine. It has a new starter, coil, module, wires, and plugs.
I am not sure where to go from here. Where can i begin troubleshooting?
I am not sure where to go from here. Where can i begin troubleshooting?
Thread Starter
Junior Member
iTrader: (4)
Joined: Jun 2008
Posts: 16
Likes: 0
From: Minot Afb, ND
Car: 1988 Chevrolet Camaro
Engine: In the market
Transmission: 700R4
Axle/Gears: 2.77
Re: Engine will not crank... Please help..
well motor is not cranking at all so i wasnt sure whether or not the dist coil and all had any affect. figured if the coil or module were bad that the engine would crank but not ever start. so your saying i should check the pickup and the dizzy? the coil and module do have miles on them so they could potentially be bad.
Junior Member
Joined: Dec 2007
Posts: 11
Likes: 0
From: Palmetto, Florida
Car: 1991 GTA
Engine: 350 TPI
Transmission: Stock
Axle/Gears: Stock
Re: Engine will not crank... Please help..
Does your car make any noise at all when you turn the key or do you get no sound at all? I have been told sometimes the chip in the key goes bad and the ignition will not let the car do anything at startup. Don't know if this helps.
Thread Starter
Junior Member
iTrader: (4)
Joined: Jun 2008
Posts: 16
Likes: 0
From: Minot Afb, ND
Car: 1988 Chevrolet Camaro
Engine: In the market
Transmission: 700R4
Axle/Gears: 2.77
Re: Engine will not crank... Please help..
thanks for your advice and thanks tgo. With a little research, helpful threads, a lot of patience, and a multimeter I was able to trace the problem to the starter enable relay. I pulled the cap off and saw one of the prongs was scortched. This immediately said FRIED.. with a little testing indeed that was it. Definetely learned a lot on this one.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM





