Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

Newbie, Mods?

Thread Tools
 
Search this Thread
 
Old May 28, 2009 | 06:44 PM
  #1  
thelastz28's Avatar
Thread Starter
Member
 
Joined: May 2009
Posts: 123
Likes: 0
From: Victorville, CA.
Newbie, Mods?

Hey guys, sorry if this is in the wrong place...

I recently bought an 88 Trans Am GTA. I was wondering where to start with engine mods? The car already has shortie SLP headers and a aftermarket thermostat. It also has a descent sounding muffler. Are there any good CAI kits or cat-back exhaust systems? Thanks for any help.
Reply
Old May 29, 2009 | 02:15 AM
  #2  
johnny89345's Avatar
Member
15 Year Member
 
Joined: Apr 2007
Posts: 389
Likes: 0
Car: 1987 iroc z
Engine: 350tpi
Transmission: 700r4
Axle/Gears: 342
Re: Newbie, Mods?

get magnaflow. i just installed it and love it and absolutely no clearance issuses
Reply
Old May 29, 2009 | 10:40 AM
  #3  
thelastz28's Avatar
Thread Starter
Member
 
Joined: May 2009
Posts: 123
Likes: 0
From: Victorville, CA.
Re: Newbie, Mods?

Thanks for the reply. I had Magnaflow on my LS1 and really liked the sound on it.
Reply
Old May 29, 2009 | 11:45 AM
  #4  
Unholy 89's Avatar
Member
 
Joined: Aug 2005
Posts: 293
Likes: 0
From: Hotlanta, GA--- Home of the Bandit!
Car: '89 5spd GTA
Engine: 305(LB9) TPI
Transmission: T-5
Axle/Gears: Borg-Warner 3.42
Re: Newbie, Mods?

Flowtech Afterburner on mine and I really like it. Much cheaper that Magnaflow or Flowmaster. Made by Holley.
http://store.summitracing.com/egnsea...05215&D=305215

Best thing I ever did to mine was put a Hypertech fan switch. Turns the cooling fans on earlier and runs much cooler. I hated watching the temp gauge.

Other cheap mods include:
Adjustable fuel pressure regulator, Throttle body coolant by-pass, headers, adjustment of the TPS Sensor, Mallory digital ignition

Last edited by Unholy 89; May 29, 2009 at 11:49 AM.
Reply
Old May 30, 2009 | 02:54 AM
  #5  
johnny89345's Avatar
Member
15 Year Member
 
Joined: Apr 2007
Posts: 389
Likes: 0
Car: 1987 iroc z
Engine: 350tpi
Transmission: 700r4
Axle/Gears: 342
Re: Newbie, Mods?

since you probaly have a 165 stat in there you should get the fan swich by hypertech first so the car will run properly, well much cooler and you wont have to watch the guage fluctuate. it really all depends on your budget. i would not get msd yet its too expensive for very little gain if any. i would get a afpr and air foil. i bought them together and noticed a pretty nice gain
Reply
Old May 30, 2009 | 08:20 PM
  #6  
thelastz28's Avatar
Thread Starter
Member
 
Joined: May 2009
Posts: 123
Likes: 0
From: Victorville, CA.
Re: Newbie, Mods?

What are the AFPR and air foil for? Are there any air intake kits for this car?
Reply
Old May 30, 2009 | 09:49 PM
  #7  
johnny89345's Avatar
Member
15 Year Member
 
Joined: Apr 2007
Posts: 389
Likes: 0
Car: 1987 iroc z
Engine: 350tpi
Transmission: 700r4
Axle/Gears: 342
Re: Newbie, Mods?

yea there are cold air intakes. air foil say adds like 8 hp idk how true that is but its cheap and afpr is adjustable fuel pressure regulator. you raise you psi at the rail and gain a few horses definitly noticable up top
Reply
Old May 30, 2009 | 10:30 PM
  #8  
thelastz28's Avatar
Thread Starter
Member
 
Joined: May 2009
Posts: 123
Likes: 0
From: Victorville, CA.
Re: Newbie, Mods?

Thanks for the answers. Do the SLP siemese runners make a big difference? Is the SLP CAI still being sold? Where do you guys buy your performance parts?
Reply
Old May 31, 2009 | 01:54 AM
  #9  
johnny89345's Avatar
Member
15 Year Member
 
Joined: Apr 2007
Posts: 389
Likes: 0
Car: 1987 iroc z
Engine: 350tpi
Transmission: 700r4
Axle/Gears: 342
Re: Newbie, Mods?

i go ebay because like most camaro owners im poor. do a search on tpi siamesed runners are good but you have to, well would be best off if you also ported the plenum for a set of those. and as far as cai for a bird idk i have an iroc and love the factory setup as far as look im currently modifying it to the grill like a ram air o and to answer your ? yes they say like 20hp i dont thing that much but youll definitly feel it
Reply
Old Jun 1, 2009 | 06:49 AM
  #10  
Unholy 89's Avatar
Member
 
Joined: Aug 2005
Posts: 293
Likes: 0
From: Hotlanta, GA--- Home of the Bandit!
Car: '89 5spd GTA
Engine: 305(LB9) TPI
Transmission: T-5
Axle/Gears: Borg-Warner 3.42
Re: Newbie, Mods?

They still make the SLP CAI kit for the TA...you can order it from Summit. Before I spent the $'s on siamesed runners, I'd put a set of headers on.
Guaranteed HP with those. I have no experience with the airfoil...it is supposed to smooth the air entering the plenum, but I dunno....you can find them on eBay pretty cheap.
Reply
Old Jun 4, 2009 | 10:05 PM
  #11  
thelastz28's Avatar
Thread Starter
Member
 
Joined: May 2009
Posts: 123
Likes: 0
From: Victorville, CA.
Re: Newbie, Mods?

Thanks guys.
Reply
Old Jun 4, 2009 | 10:42 PM
  #12  
Stephen's Avatar
Banned
iTrader: (12)
 
Joined: Jul 1999
Posts: 12,212
Likes: 13
From: Bertram (outside Austin), TX
Car: 87 GTA
Engine: L98
Transmission: 700R4
Axle/Gears: Dana M78 3.27 posi
Re: Newbie, Mods?

Originally Posted by thelastz28
Thanks for the reply. I had Magnaflow on my LS1 and really liked the sound on it.
I have a Mgnaflow cat & LS1 TSP Rumbler cat back on my 87 GTA, L98.

Love the sound!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
rubblerubble
Transmissions and Drivetrain
18
Mar 13, 2016 06:57 PM
Quzyle
DIY PROM
13
Oct 15, 2015 03:35 PM
Cole Curtis
Theoretical and Street Racing
9
Oct 3, 2015 12:26 AM




All times are GMT -5. The time now is 03:26 AM.