New Engine Thoughts
#1
Member
Thread Starter
Join Date: Nov 2007
Location: Cordova, TN
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Pontiac Formula 350
Engine: 350 tpi
Transmission: 700
Axle/Gears: 3.27
New Engine Thoughts
My 1989 Formula 350 engine is about to be toast. I can purchase a L31 vortec engine outof a 99 Suburban that the bottom end needs a little work for a couple hundred bucks.
I also can purchase a vortec/tpi intake and a ZZ4 cam.
My questions are if I will need to get the 062 cast heads worked on to work with the ZZ4 cam or would I be better off keeping them as is and reusing my L98 cam?
Also with my setup being a MAF car would I need a prom change with the change of a cam? Would the present prom be fine with just the vortec heads?
Forgot to point out I plan on keeping the TPI in all scenarios.
Thanks
I also can purchase a vortec/tpi intake and a ZZ4 cam.
My questions are if I will need to get the 062 cast heads worked on to work with the ZZ4 cam or would I be better off keeping them as is and reusing my L98 cam?
Also with my setup being a MAF car would I need a prom change with the change of a cam? Would the present prom be fine with just the vortec heads?
Forgot to point out I plan on keeping the TPI in all scenarios.
Thanks
Last edited by megtom2; 04-05-2010 at 05:45 PM.
#2
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,896
Likes: 0
Received 82 Likes
on
53 Posts
Car: 92 Firebird
Engine: Supercharged 6.0
Transmission: T56
Axle/Gears: 8.8 3.73
Re: New Engine Thoughts
Use your L98 heads and cam then its a direct swap. Compression is comparable and the internals are updated
Thread
Thread Starter
Forum
Replies
Last Post
CarGuyDennis
Organized Drag Racing and Autocross
137
12-06-2016 11:02 PM