AFR Head Milling ??
Thread Starter
Member
iTrader: (9)
Joined: Aug 2006
Posts: 216
Likes: 0
From: Los Angeles
Car: 88 Iroc-Z
Engine: 355 AFR-195 FIRST Fuel Inj.
Transmission: T56
Axle/Gears: ??
AFR Head Milling ??
I bought a set of used AFR 195, pn 1040, heads that were milled from 65 cc to 57 cc. Question is, does anyone have any idea how much would have hadd to be milled off this head to reach 57 cc?
I ordered a FIRST TPI intake, but Ken needs to know how much was milled off my heads in order to make the modifications so the intake will fit my combo.
Thanks in advance.
I ordered a FIRST TPI intake, but Ken needs to know how much was milled off my heads in order to make the modifications so the intake will fit my combo.
Thanks in advance.
Joined: Sep 2005
Posts: 27,881
Likes: 2,434
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: AFR Head Milling ??
"Rule of thumb" is, .006" per cc; about every 3cc, it goes up another .001".
Yours lost 8cc, so at a rough guess, mid .050"s were hacked off.
Yours lost 8cc, so at a rough guess, mid .050"s were hacked off.
Supreme Member
iTrader: (1)
Joined: Apr 2000
Posts: 5,321
Likes: 4
From: Northern CA.
Car: '82 Z28
Engine: 350
Transmission: TH400 4,000 stall
Axle/Gears: Currie 9", 4.56 gears
Re: AFR Head Milling ??
Right from their site...
Angle Mill .008" per cc
Flat Mill .006" per cc
Angle Mill .008" per cc
Flat Mill .006" per cc
Thread
Thread Starter
Forum
Replies
Last Post
92projectcamaro
Engine/Drivetrain/Suspension Parts for Sale
11
Jan 18, 2016 08:00 AM
New2Chevy
Engine/Drivetrain/Suspension Parts for Sale
2
Sep 28, 2015 12:35 AM
