1986 camaro cold air intake question
Thread Starter
Junior Member
Joined: Oct 2011
Posts: 2
Likes: 0
1986 camaro cold air intake question
i am doing a lt1 swap in my 1986 camaro 5 speed, i would like to get a cold air intake but i dont know which one to get considering my engine space and it needs to be 50 state legal, any ideas?
Senior Member
Joined: Nov 2011
Posts: 507
Likes: 1
From: Charlotte, NC
Car: 1988 IROC-Z Camaro, 1981 Trans Am
Engine: 350 TPI, 301 N/A
Transmission: 700r4, 350thm
Re: 1986 camaro cold air intake question
Are K&N cones not 50 state legal? If they arent, i dont see why not..
But how does the Lt1's air intake look again? Its similar to the TPI setup right? If it is, a box stock replacement set would probably be the best idea. The TPI and similar setups are really great setups already, a cone really wouldnt be much of an improvement, if any at all.
If it runs to a box, just replace the box with a K&N cone.
But how does the Lt1's air intake look again? Its similar to the TPI setup right? If it is, a box stock replacement set would probably be the best idea. The TPI and similar setups are really great setups already, a cone really wouldnt be much of an improvement, if any at all.
If it runs to a box, just replace the box with a K&N cone.
Supreme Member
Joined: Jul 2009
Posts: 2,615
Likes: 5
From: PA
Car: 1996 Camaro, 1985 Camaro
Engine: 3.8, 3.4
Transmission: WC T5, 700r4
Axle/Gears: 3.23(?), 3.42
Re: 1986 camaro cold air intake question
If you have a camaro, just find a dual snorkel box. Its about as good a CAI as you could hope to have.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
db057
TBI
10
Aug 11, 2015 10:11 PM
