i posted this in the transmission forum and have got no replies.
i have a 355 sbc 700r4 trans, transgo shift kit, corvette servo, uprgaded vane and new sunshell sprag assembly. the issue im having is that at idle im getting the currnet psi:
connected:
p-125
r-200
n-175
d and od-125
2-125
1-125

disconected:
p-175
r-200
n-200
d and od-175y?
2-175
1-175
now what could be the issue? i jerked on the cable about 100 times and no pressure changes.... anybody lead me to correct way?

Whats the symptoms? Slipping tranny?

at wide open throttle 1-2 it revs up and then catches the gear, and will rev out aboyt 4500rpm

I'd take a look at the governor. Was the tranny done by a shop? If it was I'd call them up, if you installed it, i'd call transgo.

ya itwas built by a shop but the guys a dueche bag and wont return my calls. also would the governor cause the high psi? it doesnt change much even pulling the cable