Little more pep...but what pushrod length ?
#1
Little more pep...but what pushrod length ?
Well the time has come for my 6k mi. motor to receive it's top end swap. I got a set of Freedom series heads from Patriot and an RPM Air Gap intake, Edelbrock double roller timing chain and am fixing to order the 268H cam,pushrods,roller tip rockers w/ a 1.7 ratio and lifters from Comp. Only question is has anyone swapped these parts, and if so what length pushrods did you use ? Running a turbo 350 and 3.73's out back, exhaling with Hooker shortys
#2
Member
iTrader: (3)
Join Date: Aug 2006
Location: Manitowoc, WI
Posts: 360
Likes: 0
Received 0 Likes
on
0 Posts
Car: 90 Camaro
Engine: 350 tpi
Transmission: t56
Axle/Gears: 4.10
Re: Little more pep...but what pushrod length ?
Get your engine put together with the new parts and buy a pushrod length checking tool for $20. The extra few days it takes to wait for the correct pushrods to come in is going to be much better (and cheaper) than taking a guess and picking the wrong length.
Thread
Thread Starter
Forum
Replies
Last Post
wigmobile
Electronics
3
09-17-2015 03:38 PM