Hello all, im assembling my motor and am stuck at the heads. I have an early 70's 350, ported 92 fbody 305 heads, performer intake, LT headers, edelbrock performer-plus camshaft and lifters, new headers back 2.5 exhaust, a few other things. Just a street motor. Not for 5k+ RPMS. I didn't keep the pushrods or rockers from the 305 heads due to wanting either 1.5 or 1.6 roller tip or full rollers, but i should have at least kept the rods cause now, i am trying to figure out what size rods to order. My question is, what was the stock rod length for the center bolt 305's? i do have the 350 pushrods but are they the same length as 305 rods?