Chevy High torque starter
07-18-2013, 11:54 PM
#1
Member
Thread Starter
Join Date: Feb 2010
Location: Dover AFB, Delaware
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Iroc-Z
Engine: 5.7
Transmission: 700r4
Axle/Gears: 3.23
Chevy High torque starter
Hey everybody. I'm hoping someone could shed some light on how to wire a high torque starter. There are three terminals. The first two are obvious, they are both the same size I believe one is for battery the other runs to the motor itself. The only problem that I have is the spade terminal. The spade terminal on the original starter was a stud with a nut on top that the smallest wire slipped on, then the nut was threaded on. What I have now is just a spade with no stud or nut. How am I supposed to get the small wire on the spade terminal? 
07-19-2013, 12:07 AM
#2
Supreme Member
iTrader: (13)
Join Date: Apr 2005
Location: Not in Kansas anymore
Posts: 7,733
Likes: 0
Received 11 Likes
on
11 Posts
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: Chevy High torque starter
http://www.radioshack.com/product/in...ductId=2103499
Cut the lug off the wire and crimp on a spade connector ?
Cut the lug off the wire and crimp on a spade connector ?
07-19-2013, 12:12 AM
#4
Member
Thread Starter
Join Date: Feb 2010
Location: Dover AFB, Delaware
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Iroc-Z
Engine: 5.7
Transmission: 700r4
Axle/Gears: 3.23
Re: Chevy High torque starter
I was also wondering If i could take the solenoid off the old starter and put it on the high torque starter
07-23-2013, 03:25 AM
#6
Member
Thread Starter
Join Date: Feb 2010
Location: Dover AFB, Delaware
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Iroc-Z
Engine: 5.7
Transmission: 700r4
Axle/Gears: 3.23
Re: Chevy High torque starter
Yeah, you are right. I ended up just cutting the tip of the wire and inserting and crimping a space terminal connector.
Thread
Thread Starter
Forum
Replies
Last Post
mhatfield 14
Tech / General Engine
5
10-24-2015 07:48 AM
