Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

1992 z28 305tpi timing/knock problems

Thread Tools
 
Search this Thread
 
Old Mar 10, 2014 | 08:48 PM
  #1  
joshIJolson's Avatar
Thread Starter
Junior Member
 
Joined: May 2011
Posts: 6
Likes: 0
From: Roseville, CA
1992 z28 305tpi timing/knock problems

Ok so I picked up a 1992 Camaro z28 about four months ago with the 305tpi in it, it has the auto trans and around 160k miles. I'm having a problem where I get and intermittent knock signal, and when I try to accelerate it retards the timing back to -3. I tried replacing the knock sensor and connector and the problem went away for a day or two then came right back. It seemed to start the first time I drove it in the rain. But that might have just been coincidence Because it was intermittent at first now its pretty damn consistent and I haven't driven it in rain since I replaced the connector. It is a t-top car and they do leak, I'm not sure if that would cause any problems. it comes in and runs behind the a-pillar trim especially on the passenger side. I know the ecu is over there but its tucked in the dash pretty good so I don't thing any water is getting on it. Hopefully someone will be able to help. And if this topic is already posted please don't yell at me I've searched but to no avail. ANY help would be amazing.
Reply
Old Mar 10, 2014 | 08:57 PM
  #2  
joshIJolson's Avatar
Thread Starter
Junior Member
 
Joined: May 2011
Posts: 6
Likes: 0
From: Roseville, CA
Re: 1992 z28 305tpi timing/knock problems

Here are some pics of the car to make it less boring
Attached Thumbnails 1992 z28 305tpi timing/knock problems-9d5382ec816b11e39b5f1275d9cb4214_8.jpg   1992 z28 305tpi timing/knock problems-photo-5.jpg   1992 z28 305tpi timing/knock problems-wp_20140222_005.jpg  
Reply
Old Mar 13, 2014 | 01:06 AM
  #3  
joshIJolson's Avatar
Thread Starter
Junior Member
 
Joined: May 2011
Posts: 6
Likes: 0
From: Roseville, CA
Re: 1992 z28 305tpi timing/knock problems

Any help would be great
Reply
Old Mar 22, 2014 | 10:52 PM
  #4  
chevypower91's Avatar
Member
20 Year Member
Liked
Loved
 
Joined: Sep 2002
Posts: 273
Likes: 14
From: milton, ontario
Car: 1991 Camaro Z28
Engine: 305 cid
Transmission: 5 speed
Axle/Gears: Posi/3:42
Re: 1992 z28 305tpi timing/knock problems

Originally Posted by joshIJolson
Ok so I picked up a 1992 Camaro z28 about four months ago with the 305tpi in it, it has the auto trans and around 160k miles. I'm having a problem where I get and intermittent knock signal, and when I try to accelerate it retards the timing back to -3. I tried replacing the knock sensor and connector and the problem went away for a day or two then came right back. It seemed to start the first time I drove it in the rain. But that might have just been coincidence Because it was intermittent at first now its pretty damn consistent and I haven't driven it in rain since I replaced the connector. It is a t-top car and they do leak, I'm not sure if that would cause any problems. it comes in and runs behind the a-pillar trim especially on the passenger side. I know the ecu is over there but its tucked in the dash pretty good so I don't thing any water is getting on it. Hopefully someone will be able to help. And if this topic is already posted please don't yell at me I've searched but to no avail. ANY help would be amazing.
Hi. Have you checked the ignition coil, distributor pick up coil and the ignition control module?
Reply
Old Mar 23, 2014 | 03:04 AM
  #5  
eseibel67's Avatar
Supreme Member
15 Year Member
 
Joined: Jul 2009
Posts: 2,328
Likes: 9
From: Kitchener, ON
Car: 1988 GTA
Engine: LB9
Transmission: T5
Axle/Gears: 3.45
Re: 1992 z28 305tpi timing/knock problems

Just a couple of ideas assuming your engine is stock.

Did you make sure the new knock sensor was correct? A 350 and 305 one look the same but work different.

Also, since you said the problem started in the rain, I would check connections for corrosion. There is a 5-pin spark module near the master cylinder, check the connections there.
Reply
Old Apr 26, 2014 | 01:44 PM
  #6  
joshIJolson's Avatar
Thread Starter
Junior Member
 
Joined: May 2011
Posts: 6
Likes: 0
From: Roseville, CA
Re: 1992 z28 305tpi timing/knock problems

Thanks for the replies. I ended up fixing it by replacing the knock sensor and the connector. The connector was all cracked up and dried out. Thanks very much for your time I really appreciate it
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Vintageracer
Camaros for Sale
12
Jan 10, 2020 05:33 PM
1992CamaroGirl
Electronics
6
Dec 25, 2017 08:45 PM
Bryan F
Tech / General Engine
2
Aug 18, 2015 02:28 PM




All times are GMT -5. The time now is 12:36 AM.