How to test ignition coil?
#1
Member
Thread Starter
iTrader: (1)
Join Date: Sep 1999
Location: Arlington, TX
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Formula
Engine: 6.2 383 TPIS Miniram
Transmission: T-56
Axle/Gears: Moser 9" 4.11
How to test ignition coil?
We picked up some spare parts the previous owner of our bird found in his garage a bit back. Two of which are ignition coils. I obviously have no need to hang onto non working parts.
At one point and time I had a printout of what terminals to check and what the readings should be but can't seem to find it anywhere. Is there write up somewhere on what terminals to check with a volt meter to find out if these are good or just trash?
At one point and time I had a printout of what terminals to check and what the readings should be but can't seem to find it anywhere. Is there write up somewhere on what terminals to check with a volt meter to find out if these are good or just trash?
#3
Member
Thread Starter
iTrader: (1)
Join Date: Sep 1999
Location: Arlington, TX
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Formula
Engine: 6.2 383 TPIS Miniram
Transmission: T-56
Axle/Gears: Moser 9" 4.11
Re: How to test ignition coil?
Not sure what you mean but it looks like that one with the 4 terminals and the one plug wire terminal. Does test one get tested against the magnet since that's what it's pointing to? I'll have to stick paper clips in the terminals because my lead points are too fat to fit lol.
The following users liked this post:
Joel vallejo (09-05-2022)
Thread
Thread Starter
Forum
Replies
Last Post
jfox55
Tech / General Engine
8
04-08-2002 05:49 PM