I just intalled new ES Poly mounts and when I lowered the engine the bottom tabs are in contact with the plate but the rear tabs dont even touch. They are like (inside) the tabe rubbing up against the inner wall. I have installed these correctly like the paper said and everything. Is this normal? I looked at the stock one on ther other side and it looks as if all the tabs are touching. Did I do soemthing wrong?

 

sounds like you put them in backwards in the clamp

if you look at the mount one tab is higher than the other

they go in a certain way .........it will also take a bit of trying to get them to set right if they are in the right way

I would just check them for the position in the clamp ...........but you said you did

so it will take a bit of positioning and moving to get it right

Hope that Helps

 

Yea they are in right I double and even triple checked. I am going to do the other side tomorrow to see whats up.,