Guys, what hardware/fasteners go here in these holes? I've got the filters in the lower box, and the upper box sealed to the lower via the spring loaded twist clips, but I haven't had the whole assembly fastened to the nose and radiator support in 15 years!!!!!!! ....finally getting around to fixing all the little stuff. Anyhow, I know that along the radiator support it uses push pins/clips which I have, but it looks like the front 5 along the front edge, and 1 each on the left and right use screws. Anyone have a pic? I did dig out one the female body clips attached to the nose, so I can figure out the thread, but what does the actual fastener look like?

 

7mm hex screws with floating washer. Don't see a pt# listed anywhere.

 

Yup; just yerbasic #8 screw, about ¾" long, 7mm hex head, large floating washer. There's A BUNCH of them all around there you can look at to match against.

 

Cool, thanks guys. I thought I could probably figure it out, but.....also knew someone here would know.

 

Love the graphic there!

 

Thanks! -although now I need to find somewhere to put it! ....switched to an open element. May build a cold air, but so far so good. Just couldn't breathe through the factory air box.