Electrical issues
Thread Starter
Junior Member
Joined: Jun 2015
Posts: 36
Likes: 2
Electrical issues
87 iroc 305/carb
Volt and temp gauges arent working. Fuse is good and getting power to cluster,as I have taken the actual gauge out of cluster, and checked with a test light. No power to alternator plug. Anything help/advice would be greatly appreciated
Volt and temp gauges arent working. Fuse is good and getting power to cluster,as I have taken the actual gauge out of cluster, and checked with a test light. No power to alternator plug. Anything help/advice would be greatly appreciated
Joined: Dec 2004
Posts: 16,754
Likes: 996
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Electrical issues
For the temp sensor. You can ground the green wire at the sender. The sender is in the drivers side head between cylinder 1 & 3. If the gauge pegs the wiring is good and you have a bad sender.
Joined: Dec 2004
Posts: 16,754
Likes: 996
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Joined: Dec 2004
Posts: 16,754
Likes: 996
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Thread
Thread Starter
Forum
Replies
Last Post
CarAteMyMoney
Tech / General Engine
8
Jun 22, 2003 10:31 PM
