L98 best heads to match torker high rise manifold and Holley 1050 dominate carb
Thread Starter
Junior Member
Joined: Jan 2020
Posts: 4
Likes: 0
Car: 91 z28
Engine: 350 tpi
Transmission: Auto
Axle/Gears: Solid 3.73 posi unit
L98 best heads to match torker high rise manifold and Holley 1050 dominate carb
I have 2 questions.I bought a torker high rise manifold I wanted to get rid of the tpi and was wondering if a set of trick flow 2.02 195s would bolt up to these or not.if not what aftermarket heads would and will a Holley 1050 dominator pump too much gas and air into the motor?
Supreme Member
Joined: Jan 2008
Posts: 1,332
Likes: 565
Car: 1986 IROC Z
Engine: 5.0 TPI
Transmission: 700R4
Axle/Gears: 3.23 Posi
Re: L98 best heads to match torker high rise manifold and Holley 1050 dominate carb
I have 2 questions.I bought a torker high rise manifold I wanted to get rid of the tpi and was wondering if a set of trick flow 2.02 195s would bolt up to these or not.if not what aftermarket heads would and will a Holley 1050 dominator pump too much gas and air into the motor?
BTW, a 1050 Dominator, which is a race-only carburetor, won't bolt onto a Torker manifold.
Re: L98 best heads to match torker high rise manifold and Holley 1050 dominate carb
Is this a joke, or did someone use Google Translate to post this string of questions?
T98 High Growth Manifold and Holley 1050 Carburetor L98 Head
I have two questions. I bought a lot of high growth torso. To get rid of Tpi, there is no doubt whether the tricky 1952 stream is 2.02195. What will market leaders want next, and will Holly 1050 want it? Do you pump too much gas and air into the motor?
I have two questions. I bought a lot of high growth torso. To get rid of Tpi, there is no doubt whether the tricky 1952 stream is 2.02195. What will market leaders want next, and will Holly 1050 want it? Do you pump too much gas and air into the motor?
Last edited by Drew; Jan 11, 2020 at 01:42 PM.
Thread Starter
Junior Member
Joined: Jan 2020
Posts: 4
Likes: 0
Car: 91 z28
Engine: 350 tpi
Transmission: Auto
Axle/Gears: Solid 3.73 posi unit
Re: L98 best heads to match torker high rise manifold and Holley 1050 dominate carb
What intakes will bolt up to a set of super 23 195s then?
Supreme Member
Joined: Oct 2000
Posts: 3,167
Likes: 781
From: Park City, UT
Car: '92 Corvette, '89 1/2-a-'Vette
Engine: LT1, L400
Transmission: ZF6, T5
Axle/Gears: 3.45, 3.31
Thread
Thread Starter
Forum
Replies
Last Post