I have heard about it, but I dont really know what it is. Its a program that interfaces with my ECM, right? Well, how do I make/where would I find the plugs and wires needed to hook comp up to ECM. Also, any other info is great! Thanks!

 

I'll start you off:

the ALDL port that's near your knees under the dash, you just need to hook up a data and ground wire to it.. ground is A, and data E if i remember correctly. there's a simple schematic of the circuit you need to make floating around also. it only involves one transistor and 1 or 2 resistors. it plugs into the serial port of your laptop.

For more info hunt around the DIY Prom board. Even if you're not getting into prom burning there's enough info around there to get you started with the diagnostic aspects of the software.

Hope that helps. Anyone feel free to add or correct

--Jim--

 

Thank you, I will check it out. I guess I have to get a serial plug then?

 

Yeah, easy to pick up at radio shack, db9 female you'll need. its only like 5 bucks, little more if you buy a plastic casing for it

 

Well, guess I will have to make a run up there soon. Cuz I'll need the resistors also...