alright so i'm pulling out of my job today at midas and there is an autozone right next to it and while i was pulling out a ws6 trans am is pulling out so i rev my engine at him and he revved his and i knew he was gonna go so he downshifts and takes off and i saw it coming so i was ready so i cut around this car that was in front of me and stayed right on his *** and then we were still going but then i moved over in the other lane and was starting to pass him but then i had to turn off the exit so i could have taken him if it was a longer stretch, maybe once we got to higher speeds he might have gotten me but we got to about 80.

 

nice run, but you shouldnt race in traffic like that

anyway, whats your mods?

 

i don't normally but iv'e yet to see if i could hang with one of them and it's not often i see them around here.

350 bored .030 over
lt1 cam
edelbrock performer tbi intake
ported and polished 305tpi heads. (was going to build a 305 so i didn't get the 350tpi heads )
flowtech headers
flowmaster cat back
3.42's
chip

and thats pretty much it i think

 

About how much did those mods cost you do you think?

 

well the 350 was like 150, complete rebuild came to 1100. then the cam was like 50, heads were 75, port and polish was 500, chip was 50, headers 90, cat back 400, intake 200 3.42's 80,

so about 2700

 

A little more than I thought, but it's only because you got a full rebuild. Still cheap. Good work.

 

yea the motor was seized thank you very much for the compliment

 

nice, and i killed a Kia tonight....back up now...crazy power there...