It may be of minimal importance to everyone else, but I went to 6 different wreckers today ( Winnipeg, Manitoba) and after 3 hours I found a 7730 Ecm. It was in a 3.1 fi Corsica. It only cost me $20. After I gave the guy the money, the owner of the yard asked me how much the guy charged, I said $20 and he said I was lucky cause he charges $50. Sweetness. This is just the first piece in my 327 TPI conversion. Now I need a Speed Density wiring harness, a custom chip, all sensors, fuel lines, fuel pump, Some vaccum lines for charcoal canister, and my Miniram ( anybody got anything). But today was a good day!

Dustin

 

lol thats funny how the same place will give you 2 different prices.

 

You can just re-pin a MAF harness..Go back to the wrecker and get the connectors for the ECM..Take the pins off the connector of the MAF harness and place it on the corresponding connector hole..You can use a tiny screwdriver to push the "pins" of the connector..You can use the MAF sensor wire for your MAP sensor.Get a knock sensor from a SD system,get a PROM and the Moates piggyback/EEPROM and your set.

This is an alternative since finding an SD harness is pretty hard..

Daz

 

For vaccum lines, can't you just use windshield wiper hose...?