If you have one, know the part number for them or know a supplier that has one- please post here!!

I am yanking the a/c soon and do not want a big gaping hole in my firewall.

Thankls!

formul89@yahoo.com

 

Good luck, I've already yanked mine and can't find one anywhere. So if you find one and no one posts here with info on where to find them please post back!

 

junkyards are a rarity. gm doesn't have them anymore. i even checked their storage company for slow moving parts and they were out.
i hear s-10's can be used.
i got mine from ebay for 45 shipped off of a camaro.

 

I found one.. no, it's not for sale! A guy, I think Mark Shields, had his brother fab up a plate to make the heater/condensor box into a heater-only box.

 

I cut the fiberglass AC box in half, just on the drivers side of the blower motor & fabbed & riveted a sheet metal duct to direct the air into the pass compartment. The case part# is 3056659 & the gasket is 3048270 for 84-92 models. They are both discontinued from GM.

 

That's Funny!I have a couple of them sitting around.If ya are interested ,Make me an offer.....

 

I found one in a junkyard that is 2miles from my house.

It was a b!tch to get out because of one bolt.

Not bad for $20.00 with the blower motor. The motor won't work with the harness my car has, so I will tell them it doesn't work and get my $15.00 for the motor itself back!!

:rockon:

 

Hey, i'm pretty sure that you have to adapt you factory harness to the connector on that box because the A/C box blower motor wont work with the non a/c box.....

Email L9T8Z about it from the mfba board, he'll let you know

 

Hey,

I actually havn't gotten around to wiring mine up yet, but the problem is the A/C motor's fan is longer than the non a/c model. YOu MAY be able to swap fans on the actual motor.. Give it a whirl, or maybe I do. when it gets cold out.

which.. will probably be in a few weeks.
freaking new england.

-- Joe

 

I noticed that the fan is longer on the A/C model too.

Another interesting fact is the model I have was manufactured by Hurst, as in transmissions!! Has the logo molded right in to the plastic!

I'm going to check Autozone to see if they might have a non-A/C blower motor with the weather pack connector.

 

heres what i did to mine.......

 

Went to Pep Boys and picked up a Siemens blowe motor for an A/C car. The design is a little different, allowing the fan from the non-A/C motor to fit.

I will be installing the box and fan tonight to see if it does work.