I am building a 383 motor for my TPI Camaro, the engine builder had my AFR190 heads flow tested and came up with the following cam specs:

CAM motion
112 centerline

IN / EX
225 / 231 Dur at .050
0.554 / 0.560
Rocker Ratio 1.6

My question is, will this be ok for the superram and the computer, what can I expect
from this engine. The cam is installed and the engine is ready to go in the car.

Thanks for you answers,

 

I would go with the Lpe 219.

In A SR'ed 383 w/ AFR heads, its hard to argue with the results that Cam has given people.

Why Experiment ?

 

That cam would be fine. For comparison, that LPE cam is 219/219, .560/.560 on 112 lsa.

 

I answered this question on the aftermarket board, but I will say it here too. I would think high 11's at around 115 MPH after tuning is a reasonable goal. Cam should be fine based on the given specs.