anyone running halteh e6gm?
#1
Member
Thread Starter
Join Date: Aug 2001
Location: Sydney,NSW,Australia
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
anyone running halteh e6gm?
i just bought the e6gm ecu anyone done the conversion to map? mine is maf powered could anyone give me the details as to which ecm pinout you tap into to connect the three wires also your thoughts on the ecu capabilities on controlling tpi from what i understand it dosent control emmisions or ses but is very adjustable with cars that have been modified any thoughts?
#2
Member
Join Date: Mar 2000
Location: Moncks Corner
Posts: 480
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Iroc Z Cnvertible
Engine: 409 SR
Transmission: 6 speed
I love mine.
Install was simple, had to re-pin either one or two pins (can't remember which) on the ECM connector and tap into a 5+V reference for the new MAP sensor. Did you not get the manual with your Haltech showing the wiring chart in the back?
Install was simple, had to re-pin either one or two pins (can't remember which) on the ECM connector and tap into a 5+V reference for the new MAP sensor. Did you not get the manual with your Haltech showing the wiring chart in the back?
#3
Member
Thread Starter
Join Date: Aug 2001
Location: Sydney,NSW,Australia
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
no didnt get the manual i bought it second hand what did you do with emmisions ?air ,egr dosent worry me they are deleted from my engine but canister is the only worry since it has to purge during idle i think, i dont want to be caught having a canister filled with raw fuel did you delete canister if yes which way did you go by doing it any input would be appreciated since its going to be a new project for me with the haltech thanks
#4
Member
Join Date: Mar 2000
Location: Moncks Corner
Posts: 480
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Iroc Z Cnvertible
Engine: 409 SR
Transmission: 6 speed
I had removed all emissions stuff by the time the Haltech went in. As far as the canister I don't think you need to even touch it. I'll look into it cause thats an interesting question.
#5
Member
Thread Starter
Join Date: Aug 2001
Location: Sydney,NSW,Australia
Posts: 102
Likes: 0
Received 0 Likes
on
0 Posts
yeah it definately dosent control the canister i saw the ecm pinouts i wonder if we could just remove it but i think the hoses that are routed help the tank from vapour lock
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
12-02-2016 06:33 PM
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM